Pump/Skimmer To Remove Dye Penetrant From Rinse Water
THE KELLER TKO-10-DP CONTINUOUSLY REMOVES
DYE PENETRANT FROM A RINSE WATER TANK
When to Use a Keller TKO-10-DP Pump/Skimmer:
Dye penetrants are applied to precision parts to permit finding cracks or other flaws in the surfaces of the
parts. After the parts are inspected, the bulk of the penetrant is removed by immersion in a water rinse
tank. The dye penetrant rinsed off the parts floats to the top of the tank. lf the penetrant builds up to cover
the surface of the rinse tank, the cleaning process is impaired. Without treatment, the water in the rinse
tank must be dumped frequently. The TKO-1O-DP continuously removes the dye penetrant from the
surlace of the rinse tank and returns the cleaned rinse water to the tank.
Get these benefits:
Reduce waste from the dye penetrant area and downtime for changing rinse water by 75%
Patented permanent oil separating (coalescing) element, never needs changing
Sets up in minutes-Requires minimal operator attention
How the TDK-10-DP Pump/Skimmer works:
The TKO-10-DP Pump/Skimmer is similar in operation to
conventional Keller TKO Pump/Skimmers but utilizes special materials of construction which are resistant to
attack by the dye penetrant. The TKO-10-DP pumps dye penetrant and water from the surface of a rinse tank,
removes the penetrant, and continuously returns the cleaned water at a flow rate of 180 gallons per hour. An
air-operated diaphragm pump pulls the surface liquid through an inlet device, and then through a
cartridge filter which removes solids from the liquid. The filtered liquid is pumped to the Keller oil coalescing
element, which separates the penetrant. The penetrant collects in a layer at the top of the separator tank and is
occasionally drained into a waste container, simply by opening a drain valve. No other operator attention is
required. The cleaned rinse water continuously returns to the tank by gravity.
Specifications and Ordering Information
Three R10-3150 filter cartridges supptied with each unit:
R10-3150 Filter Cartridges
Footprint of Separator Tank
14" x 14"
Height of Separator Tank
Compressed Air Requirement
0.5 SCFM @ 20 to 125 psig
Copyright 2012 by Keller Products Inc. All Rights Reserved.