978-264-0221 (fax)
info@kellerfilters.com
- Metalworking Products
PUMP/SKIMMERS TO REMOVE TRAMP OIL FROM COOLANT
FILTER CHIPS/FINES FROM COOLANT OR
CUTTING OILMETALWORKING ACCESSORIES
- Industrial Filtration Products
OIL/WATER SEPARATORS
COMPRESSED AIR PRODUCTS
- Company
- FAQs
- What information is required to specify a Keller Pump/Skimmer?
- What is the comparison between dedicated units and portable units?
- Can a Keller unit remove emulsified oil from the coolant?
- How long will coolant last in a machine if properly maintained?
- Why does Keller use only 1/2" air-operated diaphragm pumps on oil separators?
- Why does Keller not offer electric pumps as options?
- What are the disadvantages of a belt or disk skimmer compared to a Keller pump/skimmer?
- Reference Materials
Magnetic Separators
FLOW-THROUGH MAGNETIC SEPARATORS CLEAN
STEEL AND IRON CHIPS FROM COOLANT OR OIL- Permanent Rare Earth magnet --- No external power required, no moving parts,
no replaceable parts
- Three sizes for coolant or oil flow rates to
39 gallons per minute at low pressure drop
- Built-in internal bypass permits full fluid
flow even when magnet is loaded with chips
- Magnet easily cleaned in a minute with
cleaning tool provided--No dirty cartridges for disposal
Where To Use Magnetic Separators The Keller magnetic separators are ideal for operations such as mold grinding which produce a large quantity of iron or steel chips. Install a magnetic separator:
1) Downstream from the coolant pump in the coolant recirculation line. The internal bypass in the separator ensures full flow even when the magnet is fully loaded.
2) In a Keller Pump/Filter Unit PFA-1002 as a prefilter to reduce the solids load on the bag filter.Click here for information on the PFA-1002
3) To remove chips from a sump continuously in an external pumping circuit.
Contact Keller for recommendations.
How They Work Contaminated fluid flows past the outside of the cylindrical magnet, which attracts even submicron particles of iron or steel. The cleaned fluid exits through slots in the bottom of the cylinder, then to the outlet port through an internal flow passage in the magnet cylinder.
To clean, remove the magnet from the housing. Scrape the collected chips into a disposal drum using the tool provided. Cleaning time: about 1 minute
Contaminated Core Cleaning Core Clean Core
Specifications and Ordering Information
Order Designation: MAG-05 MAG-10 MAG-20 Price-Please call for prices Flow Rate (gallons per minute) 18 26 39 Magnet Length 5" 10" 20" Contamination Capacity 2 lbs 4 lbs 8 lbs Inlet/Outlet Ports 1" NPT 1" NPT 1-1/2" NPT Weight 5.5 lbs 11 lbs 19 lbs Specifications: Max. Operating Pressure 170 psig Maximum Operating Temperature 120°F Materials of Construction: Housing HeadAnodized Aluminum Housing BowlSAN Clear Plastic Magnet Cover304 Stainless Steel 
- FAQs
